Trying to find the lock and unlock wires for a push button start system for 2014 Tundra

I bought an Easyguard push button/remote start kit for my Tundra. It is mostly plug and play. However, there there are four wires that need to be tapped into the existing system (brake, horn, lock and unlock). I am having a hard time finding which plug behind the driver's side kick panel has the lock and unlock wires to tap into. Anyone have a good image of the multi pin connector that hosts those wires and a diagram of the wires for that multi pin connector?

 

Welcome to the forum.
You can find your wiring diagrams here.
It will have your wire colors, connector, and pin diagrams as well.

Ultimate TUNDRA Wiring Diagrams Collection | Toyota Tundra Forum (tundras.com)

Here are the instructions for the tailgate popnlock.
It should have the lock/unlock info you need.
Test the wires with a DMM to make sure..

PL8547HD_Toyota-Tundra.pdf (vehiclesecurityinnovators.com)

 

I have looked through that whole document before. None of my plugs match up with what this document is showing for the door locks in the area behind the driver's side kick panel. I am at a loss in figuring which plug contains the door lock and unlock wires and if identified which ones are the specific wires.

 

Following, as I’m interested in a push start for my 2017 Platinum.

OP, what all did you buy? Anything extra aside from the kit?

 

I don't know anything about your install, I guess you need connector NJ2.
Pink wire - unlock.
Light green wire - lock

If you need the wireless door lock/unlock circuit, that is a whole other 10 pages of wiring diagrams.

Hope this helps..

 

That is because the document shows the wiring for the passenger kick panel..

 

Yup. Door lock/unlock is on the passenger side.

 

The NJ2 on the driver's side should(?) be what he needs, I think..

 

I would have assumed it would be a tap similar to a tailgate or canopy power lock. Thats usually done on the passenger side I think in MJ1. Just an assumption though.