05’ DC limited 4x4 - Keep It Simple (KIS)

This is my KIS (keep it simple) build.

Traded vehicles with my Dad in December. Truck has 187k miles with 8 PO’s.

Has some rust on the frame but my Dad previously sprayed it down, but said I need to do it again.

My Dad fixed within the year:
Transmission Fluid Flush
LBJ L and R: BECK/ARNLEY 1015281 (might need to be replaced sooner then later)
Radiator - Denso
Radiator Fluid Flush
Drive Shaft NEW
Serpentine Belt Tension-er
Serpentine Idler Pulley
Acid Paint Rust Stop
Rear Wheel Cylinder
Power Steering Fluid and pump
Rear Brake Shoes & Drums
Front Disc & Pads - Detroit Axle
Front R & L LBJ
Monroe Strut R & L - will be replaced with Bilstein 4600’s with OME springs.
Tie Rod End Inner and Outer
Sway Bar Link
Front Hub Bearing & Seal
Front CV Shafts
Front Upper Ball Joint
Stablizer Bar Sleeves
Allignment
Diff Lube Changes

Upgrades and repairs:
Interior LED lights - 12/30/24
Phone mount on dash
Repaired stock woofers with new foam - 01/20/25
Installed new R&L rear door checks - 12/30/24

Future upgrades:
Install Bilstein 4600's on all 4

 

I didn't see TB and LBJs listed...

 

The LBJ's were done in 2023 but they are the BECK/ARNLEY 1015281, I have not heard good things about these. The timming belt was inspected and is in goog condition. I might want to install the LBJ with OEM when I install the new 4600's.