1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

3D print, brake pressure bleeder adapter

Discussion in '3rd Gen Tundras (2022+)' started by raylo, May 18, 2023.

  1. May 18, 2023 at 5:39 AM
    #1
    raylo

    raylo [OP] not so new member

    Joined:
    Oct 1, 2021
    Member:
    #68780
    Messages:
    2,234
    Gender:
    Male
    Frederick, MD
    Vehicle:
    2023 SR5 DC 6.5 bed Lunar Rock, TRD OR +Options
    DashCam, amp & sub, DIY rear seat delete, cat shield
    I made this for my Tacoma back in the day and it turns out that our Tundras have essentially the same master cylinder design and dimensions save for the new threaded caps. The threads for the MC cap caused me to have to modify my old design to make it shorter but this new one should be backwards compatible to the older style MCs with the rubber snap on caps.

    In any case, my 4 month old Tundra is not even close to needing this service yet but since some of you guys have had them for almost 2 years and are racking up the miles maybe someone here could benefit from this now.

    Some minor assembly of the clamp is required but I have provided the parts list.

    Toyota Tundra Power Brake Bleeder Adapter by raylo32 - Thingiverse
     

Products Discussed in

To Top