Anyone lifted your truck with a 2 post lift ?

I just got a lift installed , all the cars go up fine. I pulled the 2020 tundra TRDPro in and on the driver side the frame is hard to get a good jack point in the rear with rotary frame lift adapters. First lift and front wheels up , back on ground. Tried repositioning and figured I would do a little research first. The book jack points don’t seem to work for lift arms. Can I lift at the spring perches ? wish I paid attention when it’s been at the dealer. Anyone seen this or experienced this ?

 

NO! It’s normal for the front to lift before the rear. I swear my rear sags about 6” more than the front when suspended. Don’t let the truck scare you. You’ll want the b pillar to be just rear of the posts before you even position the arms. As in you draw a line from the door and it lines right up with the back of the post. It’ll look like it wants to fall backwards, but it’ll be fine. I don’t have any good pics to show you right now. This is best I have. At least you can see the rear sags way more than the front.

 

Thanks for the info and pic. Do you position all arms on the frame? I’ll have to snag a pic tomorrow. I have an asymmetrical lift so longer rear arms.

 

Yes

 

So I was able to get it lifted to rotate the tires but it’s definitely questionable. I have a set of rotary truck adapters in order and should be here soon I think that will help in the rear where the frame goes up quite a bit. This should level it out because right now it’s definitely not level and lower in the rear.
I’ll update once those come in and show where I found the best spot to lift it keeping it level. Thanks.