Bed Dimension Question

A customer told me that the inside width of his Tundra bed was narrower in the front than it is in the back.

As far as I know, the inside width is consistent for the length of the truck.

Can anyone confirm this?

 

OK I measured mine in three spots. In between the bedrails up against the plastic caps. At the rear it was 62-11/16" in the middle it was 62-11/16" and up at the front it was about 62-1/2" . There could be discrepancies in the plastic and also the fact that the rear of the bed doesn't have any cross bracing. But seems consistent enough that it wouldn't be a factor. And on my middle measurement I measured it in a few spots near the middle and all were the same. Up until about the last foot towards the front.

Edited my number.

 

Do you have the deck rail option?

 

Yes but they are installed on top of the lineX bedliner

 

So you can confirm that the accessory rails are parallel to each other?

 

Yes sir. At the rear inside edge of the deck rail system to inside edge 62-1/2" and at the front 62-7/16.

 

Basically what I told you in my PM. Variation is expected based on stack up of multiple bolted panels, but nothing that's in the inches...

 

That's exactly what I thought. This is why I went to the experts. Thanks!!

 

Yes the I.D. is the same, it's the O.D. that really narrows down towards the back on the 3rd Gens.