Fuse/Power Block Setups for Hybrid Owners

I'm looking for a clean solution to connect my lights to a Switchpro (or similar) using a fuse block. Since the hybrid battery is underneath the rear set, I'm not sure what the best way to wire is. I don't believe there are any companies making kits for Hybrids just yet. Anyone else have photos of a good setup?

 

there is a third gen hybrid mod thread on here. I ran my old switch pros from the backseat all the way to the front dash- I did not have the longer cord you can order (and the aftermarket kit was sold out) so mine is stretched TIGHT. Wiring isn’t super tidy in my location due to space, but it work is just fine.

If I was doing it over again I would have waited for the longer switch pros cable and installed it behind the rear seat on the plastic, instead of in the under seat storage tub

 

Oh I did not know that thread existed. I'll search for that thread.I s the longer cord available through the switchpros website?

 

it is, contact them directly for it