iForce 5.7 Badges, Beware

So this weekend I removed all the badges from the truck and blacked them out. I didn't notice it when I was removing them, but when I went to reapply the block iForce 5.7 badges I realized they don't actually lay flat, the surface they're on has a curve to it. So in my frustration I pulled both of them back off. Fortunately the newly laid 3M tape was easy enough to remove. As I pulled the second one off it occurred to me - they're actually left and right badges because of the curve.
So, beware, if you remove them make sure you mark them or keep track of which one is left and right. At least learning from this mistake only cost me a little tape in the end.

 

any chance sanding is an option?