Repainting Windshield Wiper Arms

Heard of a few other users doing this so knocked it out tonight. 14mm socket. Super easy with 2 tips.

1. Tape a line where the wiper is before you take it off so you can line it up again later
2. Push the part that goes around this

Down flush with the windshield. It makes it much easier to pop off. You’ll see what I mean when you start taking it apart.

I hit them wire a wire brush and some industrial rustoleum I use to on my bumper



and I had to paint twice because when I did the first coat, it was so humid outside the paint was blotching
Round 2 I painted outside then hung in the shower



Here’s them tonight



Super easy to do and makes the truck look much better

 

Looks good, nice write up. It always cleans up the look of a vehicle doing a fresh respray for the most of the time neglected wiper arms.

I toke a different route an went with white

 

Thanks! Looks good w/ that sticker

 

I painted my cowl too.

 

Was thinking about doing that. yours turned out great.

 

I did the arms and cowl as well. Then swapped out some of the rubber seals. Looks a lot better

 

You can use Cerakote trim restorer on the cowl instead of painting it. That’s what I did, looks brand new

 

I repainted mine with black rattle can bedliner. Made a huge difference.

 

You repainted your wiper arms or your cowl black rattle?

 

Wiper arms