Rigid Pod to OEM Switch Connection

Hey Everyone,

I had these Rigid lights installed on Jeep, and ordered a Cali Raised OEM style switch. I know I need to add connectors but I can’t find a diagram of what wire goes with what. If I remember correctly the two black on the Rigid are the ground but honestly I don’t remember. Any help would greatly appreciated

 

Here is a pic of my wiring when I had the original Rigid switch installed. The black striped wire attaches to the brass tab.

 

Doesn’t rigid make an adaptor to your stock wiring?

 

They currently don’t so in order to connect the Rigid wiring harness to the OEM switch I need to connect the correct wires, unfortunately where I get stuck is I can’t seem a find a diagram to connect the correct wires to each other I’ve only been able to determine ground

 

Thanks for choosing us for your OEM Switch

 

Any wiring tips on how to get your switch connected to the rigid lights?

 

Try here.....

https://trail4runner.com/2021/07/19/cali-raised-led-oem-style-switch-install-wiring-guide/

https://caliraisedled.com/pages/installation-resources

 

Any help with the function of these wires? 1st pic is Cali. 2nd is Auxbeam. I just need to know what each color Cali wire function is???
Thanks

 

Appreciate everyone’s help got it all wired up to the Cali Raised Swith works great.

 

Great! Are the Cali black and white both ground wires?

 

Green from switch to —>red/black tape wire on harness

Red from switch to —> red wire on harness

White+Black from switch to —>black wire on harness

Yellow from switch not used

 

Ok, I think this might help. I think the only difference in your setup and line is my harness has a yellow wire and yours is red/black tape. I’m just trying to eliminate the Auxbeam switch and use Cali like yours. If I understand you correctly, I just use the red-red, black-black&white, and my yellow from harness to green on Cali switch. Sound right?

 

I think so brother, that sounds about right

 

This is what Cali said

 

Ok, thanks. I’ll post when I get it in!

 

We are glad you got it wired to our switch

 

Does anyone know if a relay is required to run the cali raised switch with rigid pods? I believe the cali raised switch is only rated for 3 amps, and the rigid pods 3.5 per light.